Metal Roof Replacement in Mobile

Mobile sits on flat, sandy-clay ground along the western shore of Mobile Bay, where live oaks draped in Spanish moss drop limbs on 1950s brick ranches in Hillcrest and salt air works on older tin and shingle roofs near the water. A Metal Roof Replacement in Mobile means a full tear-off, a decking inspection, and a new metal system built for daily thunderstorms and hurricane-season wind. We work on Creole cottages in Oakleigh Garden District, Craftsman bungalows in Midtown, and 1990s subdivision homes out in Semmes and Saraland. If your roof is patched past saving, we replace it and haul the old material away. For a straight install on new construction, see our metal roof installation page.

Why Mobile Homeowners Replace Metal Roofs Instead of Patching Again

Most of the metal roofs we tear off in Mobile are 20 to 40 years old: 5V-crimp galvalume on old porches, exposed-fastener panels on sheds and carports, and first-generation metal shingles that have lost their finish. The dominant failure here is fastener and seam fatigue from wind-driven rain and summer heat, not snow load. Once the neoprene washers harden and back out, water finds the decking.

• We remove every layer of old roofing down to the wood deck, not just the top sheet.
• We replace rotten decking and fascia before any new panel goes down.
• We install new underlayment rated for high heat and coastal humidity.
• We re-flash chimneys, valleys, and skylights so the new roof is watertight at every penetration.
• We haul the old roofing to the landfill, so you do not rent a dumpster.

Replacing a tired metal roof in Mobile resets the clock on the whole assembly, not just the panels you can see from the driveway.

Key info: A 1960s brick ranch in Crichton with three layers of shingle and rusted 5V-crimp over the porch is a typical tear-off. We strip it to the deck, sister two rafters, and install a new standing seam system in one pass.

For permit thresholds and inspection rules, check the City of Mobile's building department before you schedule: City of Mobile, Alabama. Rules vary by jurisdiction and must be verified locally.

How We Run a Metal Roof Replacement in Mobile, Step by Step

We start with an on-site inspection, measure the roof, and check the deck from the attic side where we can. Then we write a scope that lists panel profile, gauge, underlayment, and flashing details. You get the number before we touch a shingle. If you are in a historic district like De Tonti Square, we confirm design review requirements before ordering material.

1. We tarp and stage the site, protecting landscaping and HVAC units.
2. We tear off the old roof and inspect every sheet of decking.
3. We repair or replace rotten decking, fascia, and drip edge.
4. We install underlayment and new flashing at chimneys, walls, and valleys.
5. We set the new metal panels and fasten them to the manufacturer's spec.
6. We clean the gutters, magnet-sweep the yard, and walk the roof with you.

Every step is documented with photos, which helps if you file an insurance claim.

Key info: A homeowner in Tillmans Corner had a 1970s shingle roof with soft decking around the chimney. We replaced four sheets of plywood, installed new step flashing, and finished with a stone-coated steel panel that matched the brick. The job took three days.

If you are weighing a full tear-off against a retrofit, our metal roof over shingles page explains when code allows a recover and when it does not.

Replacement Approaches We Use Across Mobile

The right system depends on your roof pitch, your budget, and how the house is built. Low-slope ranches in West Mobile take a different panel than a steep Victorian gable in Church Street East. Here is how the main approaches compare.

We match the profile to the house, the pitch, and the neighborhood, not to whatever is on the truck.

Metal Roof Replacement Cost in Mobile: What to Expect

Pricing starts at From $9/sq ft for a basic exposed-fastener replacement over a sound deck, and climbs from there. Standing seam, metal shingle, and stone-coated steel sit higher because of material cost and labor time. Steep pitches, multiple roof planes, and heavy flashing work all add to the total. The size of the roof is the biggest single driver.

Access matters too. A narrow lot in Old Dauphin Way where we cannot stage a dumpster in the driveway costs more to run than a wide-open lot in Theodore. So does a roof with three chimneys, skylights, or a complex valley layout. We price the job you actually have, not a square-foot average.

Get two or three written estimates and compare scope, not just the bottom line. A cheap bid that skips new underlayment or reuses old flashing will cost you more in five years. Our full metal roofing pricing page breaks down the ranges by system type.

What to Look For in a Metal Roofing Contractor Near Mobile

Hiring a metal roofer near Mobile is not the same as hiring a shingle roofer. Metal requires specific tools, specific fasteners, and specific knowledge of expansion and contraction. Ask questions before you sign anything, and do not let a salesman rush you.

• Confirm the company is licensed and insured, and ask for a certificate of insurance.
• Get at least three written estimates with itemized scope and material specs.
• Ask for local references on metal roofs they installed at least five years ago.
• Check who pulls the permit and who handles historic district or HOA design review.
• Read the warranty: material warranty and workmanship warranty are two different documents.

A contractor who cannot answer these questions plainly is not the one you want on your roof.

Ready to schedule an inspection? Reach out through our contact page or call (251) 319-2788. We serve Mobile and the surrounding communities, and we will tell you honestly whether you need a replacement or a repair.

Metal Roof Replacement in Mobile: Pricing Guide

Indicative pricing, the exact cost depends on square footage, finish, and site access. Free personalized estimate within 24h at (251) 319-2788.